Resending an Unsent Fax Document
You can configure the machine to store a fax that could not be sent by Memory Transmission due to an error in the memory and send it again later.
To use this function, configure [Detailed Initial Settings] in [Fax Settings] in advance.
In case of a power outage, or if you leave the machine unplugged from the wall outlet for about one hour or more, all the documents stored in the memory of the fax will be erased. If a document has been erased, a "Power Failure Report" listing the erased documents is printed.
When an Error Is Reported in a Report or E-mail
Press [Settings] on the Home screen.
Press [Fax Settings] on the Settings screen.
Press [Detailed Initial Settings]
[Parameter Setting] [Parameter Setting].Select bit number [0] under switch number [24], and change current value to "1".
Press [OK].
Press [Home] (
) after specifying the settings.
Documents that could not be sent are stored in the memory for a period configured by bit number [1] at switch number [24].
List of Parameter Settings
Operate on the [Check/Stop Transmission File] screen to resend a document stored in the fax memory.
Press [Fax] on the Home screen.
Press [Job Status/Stop] on the fax screen.
Press [Check/Stop TX File] on the [Job Status/Stop] screen.
On the [Check/Stop Transmission File] screen, select the document to send again, and press [Transmit Now].
Upon starting transmission, the status "Failed" changes to "Trnsmtg.". The document is deleted from the list after completing the transmission. Press [Transmission Result] on the [Job Status/Stop] screen to check the transmission result.