Inserting a Chapter Page During Copy

1. Press [Settings] on the Home screen.
   

2. Press [Tray/Paper Settings].
   

3. Press [Common Settings/Others] [Slip Sheet Tray], and specify the tray to feed slip sheets.
   
   As the paper to use for slip sheets, load paper of the same size and orientation as the paper to copy.

4. Press [OK].

5. Press [Home] () after specifying the settings.

6. Press [Copy] on the Home screen.
   

7. Press [Slip Sheet] on the Copy screen.
   
   If you cannot find the key, select the item from [Finishing].

8. Specify whether to also copy on the slip sheets, and then press [OK].
   

9. Press the paper tray select key and select the paper for the text body.
   

10. Place the original.
    Basic Procedure for Copying Documents

11. Press [Start].

Specify the separation method to copy originals while separating each chapter.

1. Press [Settings] on the Home screen.
   

2. Press [Tray/Paper Settings].
   

3. Press [Common Settings/Others] [Slip Sheet Tray], and specify the tray to feed designated sheets.
   
   You can use paper for the designation in the same size and direction as the paper for the text body.

4. Press [OK].

5. Press [Home] () after specifying the settings.

6. Press [Copy] on the Home screen.
   

7. Press [Designate / Chapters] on the Copy screen.
   
   If you cannot find the key, select the item from [Finishing].

8. Press [Not Set].

9. Select Separation method to specify the position to separate.
   
   

   • Separation method : Select the method of chapter designation.

   • Specify Desig. Position : Enter the page number of the original at the beginning of the chapter.

10. Press [OK].

11. Press [Not Set] to specify the separation mode for the next section.
    You can specify separations up to 20 locations.

12. Select the input tray to feed paper for the text body in "Main Sheet Tray".
    

13. Press [OK].

14. Place the original.
    Basic Procedure for Copying Documents

15. Press [Start].