Repeating the Original Image over the Entire Area of Paper When Copying
You can place duplicates of the scanned original on a single sheet of paper when copying (Image Repeat). To copy an original to a size smaller than the minimum size that can be copied on the machine, copy the original by combining Reduce copy and Repeat, and then cut the copied paper.
You can also specify the area to scan, and repeat only a section of the original image.
The number of images that can be repeated on a single sheet of paper when repeating the entire area of the original is determined automatically by the original size, paper size, and scaling factor. See below for the number of repeated images that can be arranged on a single sheet of paper for each paper size and orientation:
Original sizes
paper sizes4 repeats (71%)
16 repeats (35%)
A4
A3A4
A311 × 17
17 × 2211 × 17
17 × 22
Original sizes
paper sizes2 repeats (100%)
8 repeats (50%)
32 repeats (25%)
A4
A3A4
A311 × 17
17 × 2211 × 17
17 × 22
When you use the paper that loaded into the paper bypass location, you cannot use the Repeat function.
Press [Copy] on the Home screen.
Press [Image Repeat] on the Copy screen.
If you cannot find the key, select the item from [Edit].
Specify the repeating method, and then press [OK].
To repeat the entire area of the original, select [Whole Area].
To repeat only a section of the original, select [Specified Area], and then specify the base point (X1,Y1) and the scan range (X2, Y2) of the area to scan.
Press the paper input location select key, and then select the paper input location and a preset cut size.
Press 
Place the original.
Basic Procedure for Copying Documents
The original is fed into the machine automatically, and copying starts. If the original is not fed automatically, press [Start].
You can specify whether or not to print a separation line and the type of separation line by [Image Repeat Separation Line].
You can specify the Repeat function when the original size is A0 (E) or smaller.