Attaching the Paper Feed Unit
You can install a paper feed unit.
- Do not handle the power cord plug with wet hands. Doing so can result in electric shock.
- The machine weighs as follows.
IM 550F/600F: approximately 29 kg (64 lb.)
IM 600SRF: approximately 40 kg (88 lb.)
- When moving the machine, use the inset grips on both sides, and lift slowly in pairs. The machine will break or cause injury if dropped.
- Lifting the paper feed unit carelessly or dropping may cause injury.
- When moving the machine, make sure to unplug the power cord from the wall outlet and confirm that line cords and other connecting cables have been removed. Otherwise, the power cord is damaged, possibly resulting in fire or electric shock.
Do not place the machine directly on the floor.
When attaching multiple options, attach the paper feed unit first.
To attach two or more paper feed units at the same time, first stack them one upon the other, and then attach them as a single unit.
Before turning on the power, remove the packaging material from the paper feed unit.
Turn the machine off and unplug the power cord.
Remove the packaging, adhesive tapes, and a plastic sheet from the paper feed unit.
Lift the machine using the inset grips on both sides of the machine in pairs.
Lifting the machine requires two people.
When moving the machine, do not touch the following parts:
The operation panel, the ADF, and parts around them
Convex parts on the right side of the machine
Places indicated on the labels attached to the machine
The bottom of the optional paper tray
There are two upright pins on the optional paper feed unit. Align them with the holes on the underside of the machine, and then carefully lower the machine.
Plug in the power cord, and then turn on the machine.
Print the configuration page to confirm that the unit was attached correctly.
To check whether the optional paper feed unit was correctly attached, print the configuration page, and check "Attached Equipment" on the configuration page. If the unit was attached correctly, "Tray 2", "Tray 3", "Tray 4", and "Tray 5" will appear.
Settings screen type: Standard
Settings screen type: Classic
If the optional paper feed unit was not installed properly, repeat the procedure from the beginning. If it cannot be installed correctly even after trying the installation a second time, contact your sales or service representative.
To use the paper feed unit, configure the machine options in "Accessories" in the printer driver.
Specifying the Option Configuration or Paper Settings Manually