User GuideIM 350/430 series

wins

Use the "wins" command to configure the WINS server settings.

Viewing settings

msh> wins

  • If the IPv4 address obtained from DHCP differs from the WINS IPv4 address, the DHCP address is the valid address.

Configuration

msh> wins "interface_name" {on|off}

  • {on} means "active" and {off} means "inactive".

  • Be sure to specify the interface.

  • wlan can be specified only when the optional wireless LAN board is installed.

Interface name

Interface configured

ether

Ethernet interface

wlan

Wireless LAN interface

Address configuration

Use the following command to configure a WINS server IP address:

msh> wins "interface_name" {primary|secondary} "IP address"

  • Use the "primary" command to configure the primary WINS server IP address.

  • Use the "secondary" command to configure the secondary WINS server IP address.

  • Do not use "255.255.255.255" as the IP address.

NBT (NetBIOS over TCP/IP) scope ID selection

You can specify the NBT scope ID.

msh> wins "interface_name" scope "ScopeID"

  • The scope ID can be entered up to 31 alphanumeric characters.

  • Be sure to specify the interface.

  • wlan can be specified only when the optional wireless LAN board is installed.

Interface name

Interface configured

ether

Ethernet interface

wlan

Wireless LAN interface