Basic Procedure for Sending Scan Files by E-mail
This section explains how to send scanned documents as an e-mail attachment.
On the Home screen, press [Scanner (Classic)].
Make sure that no previous settings remain.
If a previous setting remains, press [Reset].
Make sure that the [Email] tab is selected.
Place originals.
If necessary, specify the scan settings according to the original to be scanned.
Example: Scanning the document in color/duplex mode, and saving as a PDF file.
Press [Scan Settings], press [Full Color: Text / Photo] in the [Original Type] tab, and then press [OK].
Press [Original Feed Type], press [2 Sided Original], and then press [OK].
Press [Send File Type / Name], press [PDF], and then press [OK].
For information about other settings, see the each section.
Specify the destination.
You can specify multiple destinations.
Press 
To use Message Disposition Notification, press [Recept. Notice].
If you press [Recept. Notice], the selected e-mail sender will receive e-mail notification when the e-mail recipient has opened the e-mail.
Press [Start].
This machine supports SMTPS (SMTP over SSL).
This machine supports Web mail sending.
If the settings are set as follows, you can send e-mails without entering anything for [Sender Name].
Depending on the security setting, the logged-in user may be specified as [Sender Name].
To use Message Disposition Notification, log in to the machine as a user and specify the sender. Note, however, that the [Recept. Notice] notification e-mail may not be transmitted if the e-mail software of the recipient does not support Message Disposition Notification.
If you press [Preview] and then start scanning, the [Preview] screen appears. You can use this screen to check how the originals are scanned and the scan setting used for scanning. After checking the preview, you can specify whether to send the file or not.
To cancel scanning, press [Stop]. Check the information displayed in the dialog box, and then press any key.
You can also store a scan file and simultaneously send it by e-mail.
After an e-mail is sent, the destination, sender, subject, text, and file name fields will be automatically cleared. If you want to preserve the information in these fields, contact your local dealer.
You cannot switch the screen while WSD destination is being specified. To clear the specified destination, display the destination in the destination field of each screen, and then press [Clear].
You can specify whether to send a file as an e-mail attachment or by sending a URL link in [File Emailing Method].
When [Login User Address Priority] is set to [On], the login user's e-mail address is specified as a destination after you log in to the machine and display the initial scanner screen.