Change Phase 2 User Name
Device Management > Configuration > Security > IEEE 802.1X > Change Phase 2 User Name

Use this page to set or change the user name used for phase 2.

Note

• If EAP Type is set to EAP-TTLS or PEAP for IEEE 802.1X, the user name is required.
• Settings on this page can be changed by the following administrator:
  • Network Administrator

New Phase 2 User Name

Enter the user name you want to set or change, using up to 31 alphanumeric characters. The "@" (at-sign) character cannot be used.

Confirm Phase 2 User Name

Enter the new user name again to confirm it.
The user name entered here must be the same as that entered earlier in New Phase 2 User Name.

Buttons

OK

Click to save the settings and return to the IEEE 802.1X page. The settings are applied when you click OK on the IEEE 802.1X page.

Cancel

Click to cancel the settings.