Interface Settings
Device Management > Configuration > Interface >
Interface Settings
Use this page to enter administrative information related to the machine's interfaces.
Some items are for reference only and cannot be changed.
To configure settings for the wireless LAN board, use the Wireless LAN Settings page.
Note
- Settings on this page can be changed by the following administrators:
- Network Administrator (LAN Type, Ethernet, and Bluetooth)
- Machine Administrator (USB)
- Some items may not appear depending on machine type or configuration.
Network
LAN Type
Switch the interface between Ethernet and wireless LAN. This is available only if the device supports both interfaces.
Note
- When Ethernet is in use, the switching option is not available.
Ethernet
Displays network interface board information. This information appears when a network interface board is installed.
Network
Displays Ethernet operation status.
MAC Address
Displays the MAC address (Media Access Control Address) of the network interface board.
Ethernet Security
Select whether or not to use IEEE 802.1X as an authentication method to protect data communication.
To configure detailed settings, use the IEEE 802.1X page.
Ethernet Speed
Specify an ethernet communication speed. Auto Select: Disable 1Gbps is selected by default. This allows the device to select the optimum speed.
Select Auto Select: Enable 1Gbps if you want to enable a communication speed of 1Gbps. However, the Auto Select: Enable 1Gbps setting will consume more power than the Auto Select: Disable 1Gbps setting in the energy saver mode.
If communication with the device fails, select 10Mbps Full Duplex, 10Mbps Half Duplex, 100Mbps Full Duplex, or 100Mbps Half Duplex.
Bluetooth
Configure settings related to the Bluetooth board. This information appears when a Bluetooth board is installed.
Bluetooth
Select whether communication using Bluetooth is active or inactive.
Operation Mode
Select the Bluetooth operation mode.
Public
You can establish the connection by searching for a Bluetooth adaptor or Bluetooth-equipped computer.
Private
You can establish the connection when registering the machine with utility. A Bluetooth adaptor or Bluetooth-equipped computer that has not registered the machine cannot be searched for.
USB
Configure USB settings.
USB
Select whether data transfer via USB is active or inactive.
USB Host
This appears when data transfer via USB is active and the device supports USB Host.
USB Host
Displays whether USB Host function is active or inactive.
Buttons
Refresh
Click to update the currently displayed information.
Note
- Before making the settings, click Refresh to obtain the machine's current status.
OK
Click to apply the settings.
Cancel
Click to cancel the settings.