Previous
Configure the following settings for initial setup of the special senders function:
Authorized Reception
Specify whether or not to enable Authorized Reception for special senders.
Special Reception Function
Specify whether or not to enable the functions applied to individual special senders (such as Forwarding per Sender and Memory Lock RX per Sender)
When you select [Off] for this setting, the functions applied to special senders are disabled and the settings of [Reception Settings] for all senders are enabled.
Bypass Tray Paper Size
Specify the paper size that will be used for the bypass tray.
Use this setting when you register a special sender that uses the bypass tray for [Paper Tray per Sender].
You can select the method of specifying size between [Auto Detect], [Regular Size], and [Custom Size]. If you select [Auto Detect], the machine recognizes the vertical length of the paper automatically.
Press [Facsimile Features].
Press [Reception Settings].
Press [Program Special Sender].
Press [Initial Set Up].
Select the function you want to program.
Configure the Authorized Reception settings when necessary.
Press [Authorized Reception], press [On] or [Off], and then press [OK].
Configure the Special Reception Function settings when necessary.
Press [Special Reception Function], press [On] or [Off], and then press [OK].
Configure the Bypass Tray Paper Size settings when necessary.
Press [Bypass Tray Paper Size], and then press [Auto Detect], [Regular Size], or [Custom Size].
Auto Detect
Make sure that [Auto Detect] is selected.
Regular Size
Press [Regular Size], and then select a size.
Custom Size
Press [Custom Size], enter the vertical and horizontal sizes of the paper using the number keys, and then press [
].
Specify a vertical size from 70 mm (2.8 inches) to 216 mm (8.5 inches).
Specify a horizontal size from 127 mm (5.0 inches) to 600 mm (23.6 inches).
Each time you press [mm] or [inch], the units switch between "mm" and "inch". If you enter a length and change the units by pressing [mm] or [inch], it is converted automatically (fractions are rounded off).
Press [OK].
Press [Exit] twice.
