Timer
Configuration > Device Settings >
Timer
Make settings for the timer functions.
Note
- Settings on this page can be changed by the following Administrator:
- Machine Administrator
Auto Off Timer
"Auto off" is an energy saving function to reduce electrical power consumption.
Select whether or not to automatically put the device into auto off mode when it is left idle for a specified period.
If you select [On], you must then specify the time period that the device waits following its last use before it goes into auto off mode.
Auto Off Activated by Ambient Brightness
This function automatically puts the device into auto off mode if a low ambient brightness is detected.
Auto Off Setting
Specify whether the Auto Off Activated by Ambient Brightness function is enabled or disabled.
Auto Off Timer
Specify the time period that the device waits before it goes into auto off mode after detecting a low ambient brightness.
Note
- The auto off timer will reset if any of the following occurs:
- If the sensor detects an increase in ambient brightness before the specified duration elapses.
- If a key is pressed, or a print is made.
Brightness Sensor Level
Specify a sensitivity level for detecting the ambient brightness.
Auto Reset Timer
Select whether to reset the device's printer settings to their initial status (as when first turned on), when the printer function is idle for a specified period.
If you select [On], you must then enter the time before reset to initial status.
Enter a value between 10 and 999 (seconds).
If you select [Off], the device settings remain until turned off.
Auto Logout Timer
Select to automatically log out the user logged in from the control panel if he/she does not use the machine for a specified period.
If you select [On], you must then enter the time period that must elapse before the user is automatically logged out.
Enter seconds between 60 and 999 (seconds).
If you select [Off], the user remains logged in until he/she manually logs out.
Auto Off Scheduler
Auto Off Scheduler
Configure the auto off scheduler.
The auto off scheduler automatically puts the device into auto off mode as specified. However, the device remains in auto off mode unless an operation is performed after the auto off period has ended.
Specify whether or not to use the auto off scheduler. To use it, specify [Daily] or [Day of the Week].
If you select [Daily], enter the time when the device goes into auto off mode and the time when auto off period ends, and then select the [Active] check boxes.
If you select [Day of the Week], specify when you want to put the device into auto off mode and the time when auto off period ends on the specified day of the week, and then select the [Active] check boxes.
For example, to put the device into auto off mode during lunchtime (12:00-13:00) and nighttime (18:00-09:00 next morning), use the following settings:
| Setting Item | Setting Value |
|---|---|
| Auto Off Scheduler | Daily |
| Auto Off Stop 1 | 09:00 (Workday begins) |
| Auto Off Start 1 | 12:00 (Lunchtime begins) |
| Auto Off Stop 2 | 13:00 (Lunchtime finishes) |
| Auto Off Start 2 | 18:00 (Workday finishes) |
If you want to give priority to the first print speed during work hours, select "Off" for [Auto Off Timer].
If you want to put the device into auto off mode all day on Saturdays and Sundays only, select [Day of the Week], and then specify the schedule for each day.
Note
- If you enter the time but do not select the [Active] check box, the auto off scheduler will not run at the specified time.
- You can enter a time between 0:00 and 23:59.
Buttons
[Refresh]
Click to update the currently displayed information.
Note
- Before making the settings, click [Refresh] to obtain the machine's current status.
[OK]
Click to apply the settings.
[Cancel]
Click to cancel the settings.