Installing the Printer Driver to Print Using the WSD Port
To print using the WSD port, install the printer driver from the "Network" or "Devices and Printers" screen on the control panel.
You can connect to the printer only if both the printer and computer are on the same network segment, or "Network discovery" is enabled. For details, see Windows Help.
Installing the Driver under Windows 8.1/10 or Windows Server 2012/2012 R2/2016/2019
Prepare the printer driver installer.
Set the CD-ROM on the computer or unzip the downloaded driver. If automatic reproduction begins, exit the installer.
Display the "Devices and Printers" screen.
Windows 10 (version 1703 or later), Windows Server 2019
On the [Start] menu, click [Windows System]
[Control Panel].Click [View devices and printers].
Windows 10 (earlier than version 1703), Windows Server 2016
Right-click [Start], and then click [Control Panel].
Click [View devices and printers].
Windows 8.1, Windows Server 2012/2012 R2
On the Charm Bar, click [Set]
[Control Panel].Click [View devices and printers].
Select a printer, and then click [Print server properties].
Click [Add...] on the [Drivers] tab.
Click [Next] on the "Add Printer Driver Wizard" screen.
Select the check box of the processor (CPU) of your computer, and then click [Next].
Click [Have Disk...] [Browse...] to specify the driver (INF file), and then click [OK].
If the CD-ROM drive is D:\, the file is stored in the following folder:
Driver
OS
Folder
PostScript 3
32-bit driver
D:\Windows\X86\DRIVERS\PS\X86\MUI\DISK1
64-bit driver
D:\Windows\X64\DRIVERS\PS\X64\MUI\DISK1
The downloaded file is stored in the "DISK1" folder.
Select the machine you want to use, and then click [Next].
Click [Finish] [Close].
Click [Add a printer] on the "Devices and Printers" screen.
Click [The printer that I want isn’t listed].
Select [Add a Bluetooth, wireless or network discoverable printer], and then click [Next]
Select the machine you want to use, and then click [Next].
To use the printer as a shared printer, specify the shared printer settings, and then click [Finish].