Replenishing the Staples (IM C530F only)
Do not place your hands inside the finisher when pulling out or pushing in the finisher's staple cartridge. You may trap your fingers in gaps inside the finisher, which could result in an injury.
Contact your consumable supplier and prepare new staples for replenishment when the “Staples are almost out.” message is displayed. Replace the staples after the message prompting replacement is displayed on the control panel.
Stapling failures or jams may occur if you use a staple cartridge other than that recommended.
Confirming the supplier of consumables
To display this screen again, press [Check Status] and then press [Check] under "Mach. Status" on the [Mach./Applic. Stat] tab.
Replenishing the staples
Replenish the staples while watching the video displayed on the screen for the procedure.
Press [Watch Video].
To display this screen again, press [Check Status] and then press [Check] under "Mach. Status" on the [Mach./Applic. Stat] tab.
Press the play (
) key.
Replenish the staples while watching the video.
If you cannot raise the upper unit by holding on both ends of the cartridge, there are staples still remaining inside. Continue using the machine without replenishing the staples.