User GuideIM 7000/8000/9000

Erasing Inside or Outside Specified Areas

When copying an original that includes soiled parts or patterns, you can specify the base point and the size of the unwanted area so that it is not reproduced on the output.

Note

  • You can specify the areas separately for the front and back sides of the original.

When erasing inside the specified area (Erase Inside)

Illustration of Erase Inside
  1. Base point

  2. Area to be erased (X2, Y2)

You can specify up to five areas to erase.

When erasing outside the specified area (Erase Outside)

Illustration of Erase outside
  1. Base point

  2. Area not to be erased (X2, Y2)

You can specify an area only.

Copying Using [Erase Inside]

1Using a ruler, measure the base point (X1, Y1) and the size (X2, Y2) of the area to erase.

Illustration of Erase Inside

Measure the base point from the top right of the original.

Each value can be specified in a range from 0 to 432 mm (0.0 to 17.0 inches).

2Press [Copy] on the Home screen.

Operation panel screen illustration

3Press [Erase Inside] on the Copy screen.

Operation panel screen illustration

If the key is not found, select it from [Edit / Stamp].

4Press [Erase Inside 1].

5When copying a two-sided original, select [Front and Back Side] or [2 Sided Setting].

Operation panel screen illustration

Front and Back Side: The same area is specified for the front and back sides of the original.

2 Sided Setting: Different areas can be specified for the front and back sides of the original.

6Enter the values of the base point (X1, Y1) and the size (X2, Y2) of the area that you measured in Step 1, and then press [OK].

7If you specify two or more areas, press [Erase Inside 2] to [Erase Inside 5], and specify the areas.

9Press [Start].

Copying Using [Erase Outside]

1Using a ruler, measure the base point (X1, Y1) and the size (X2, Y2) of the area that is not to be erased.

Illustration of Erase Outside

Measure the base point from the top right of the original.

Each value can be specified in a range from 0 to 432 mm (0.0 to 17.0 inches).

2Press [Copy] on the Home screen.

Operation panel screen illustration

3Press [Erase Outside] on the Copy screen.

Operation panel screen illustration

If the key is not found, select it from [Edit / Stamp].

4When copying a two-sided original, select [Front and Back Side] or [2 Sided Setting].

Operation panel screen illustration

Front and Back Side: The same area is specified for the front and back sides of the original.

2 Sided Setting: Different areas can be specified for the front and back sides of the original.

5Enter the values of the base point (X1, Y1) and the size (X2, Y2) of the area that you measured in Step 1, and then press [OK].

7Press [Start].