Preparing the Printer for Use with RICOH Smart Device Connector
Before using the printer with RICOH Smart Device Connector, configure the printer accordingly.
Install a Device Certificate on the printer and configure SSL/TLS Encryption Mode. If an access point in the intranet is not available, configure the access point function that is built into the printer.
For details about installing a Device Certificate and configuring SSL/TLS Encryption Mode, see Web Image Monitor Help.
To specify the SSL/TLS Encryption Mode, configure [Permit SSL/TLS Communication] according to the communication type as follows:
When using a HTTP connection: Ciphertext/Cleartext
When using a HTTPS connection: Ciphertext Priority
To disable "TLS1.2", "TLS1.1", or "SSL3.0", log in to Web Image Monitor as a network administrator, click [Configuration] under [Device Management], and then select [Inactive] for the protocol to be disabled under [SSL/TLS]. Enter at least one of these protocols. However, do not enable only "SSL 3.0". Data leaks may occur.