Installing SD Card Options
- Keep SD cards out of reach of children. If a child swallows a SD card, consult a doctor immediately.
Do not subject the card to physical shocks.
Turn the machine off and unplug the power cord.
Loosen the screw and remove the SD card slot cover at an angle.
Insert the SD card into the slot until it clicks.
If you want to use three or more SD cards simultaneously, contact your service representative.
If you use a commercially available SD card for buck up the address book, insert the SD card to lower slot.
Hook the SD card slot cover onto the opening, attach it flat against the controller board, and then fasten it using the screw.
Plug in the power cord, and then turn on the machine.
Confirm that the SD card was installed correctly.
You can confirm that the SD card was installed correctly by checking the control panel menu or configuration page.
PS3 card/XPS card: The name of the installed emulation card appears in the [Emulation Priority] of [System Settings] under [Printer Features].
If the card is not installed properly, repeat the procedure from the beginning. If it cannot be installed correctly even after reattempting installation, contact your sales or service representative.
Do not touch the card while the machine is in use. It may come loose, even if pushed only slightly. The slot cover must be reattached.