Installing the Wireless LAN interface board
Before beginning work, ground yourself by touching something metal to discharge any static electricity. Static electricity can damage the interface units.
Do not subject the Wireless LAN interface board to physical shocks.
Check the contents of the package.
Turn the machine off and unplug the power cord.
Loosen the two screws and remove the slot cover.
The removed cover will not be reused.
Fully insert the interface board.
Confirm that the interface board is firmly connected to the controller board.
Tighten the two screws to secure the interface board.
Plug in the power cord, and then turn on the machine.
Print the configuration page to confirm that the board was attached correctly.
After installing the Wireless Interface board, see Setting Wireless LAN to specify the wireless LAN settings.
Confirm that the board was correctly installed by printing the configuration page. If it is correctly installed, "Wireless LAN" will appear for "Device Connection" on the configuration page. For information about printing the configuration page, see "List / Test Print", Print.
If the board was not installed properly, repeat the procedure from the beginning. If it cannot be installed correctly even after reattempting installation, contact your sales or service representative.
Before using the board, you must configure settings from the printer control panel. For details, see Setting Wireless LAN.