Connecting Ethernet Interface
This section describes how to connect an Ethernet interface cable to the Ethernet port.
If you use an Ethernet interface cable that supports 1000BASE-T, set [Ethernet Speed] to [Auto Select:Enable 1Gbps] in [Interface Settings] in [System Settings].
Use the following Ethernet cables.
When using 100BASE-TX/10BASE-T:
Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5 or more
When using 1000BASE-T:
Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5e or more
When you use IPv6, set [Effective Protocol] to [Active] in [Interface Settings] in [System Settings]. IPv6 is inactive as a factory default. When you enable IPv6, a link-local address is automatically set.
To use IPv6, consult your network administrator.
Make sure the main power is switched off.
Connect the Ethernet interface cable to the Ethernet port.
Connect the other end of the Ethernet interface cable to a network connection device such as a hub.
Turn on the main power switch of the machine.
Indicator (orange)
When 100BASE-TX is operating, the LED is lit orange.
Indicator (green)
When 10BASE-T is operating, the LED is lit green.
Indicators (both orange and green)
When 1000BASE-T is operating, both LEDs are lit.
When Energy Saver mode is enabled, the LEDs may not light up.
Obtaining an IP address automatically (IPv4 DHCP)
The machine is set to obtain IP addresses automatically as a factory default.
Press [Home] (
) at the bottom of the screen in the center.
Flick the screen to the left, and then press the [User Tools] icon (
).
Press [Machine Features].
Press [System Settings].
Press [Interface Settings] tab.
Press [Network].
Press [Machine IPv4 Address].
Press [Auto-Obtain (DHCP)].
Press [OK].
Specifying an IP address (IPv4)
Press [Home] () at the bottom of the screen in the center.
Flick the screen to the left, and then press the [User Tools] icon ().
Press [Machine Features].
Press [System Settings].
Press [Interface Settings] tab.
Press [Network].
Press [Machine IPv4 Address].
Press [Specify].
Press [Change] next to [Machine IPv4 Address], and then input the IP address.
When you complete entering the IP address, press [
].
Press [OK].
Press [Change] next to [Subnet mask], and then enter the subnet mask.
When you complete entering the subnet mask, press [].
Press [OK].
Press [IPv4 Gateway Address], and then enter the gateway address.
Press [OK].