Settings You Can Configure Using a Web Browser

Use a web browser from networked computers to configure the security settings shown in the following table. (We use Web Image Monitor installed on this machine.)

Device ManagementConfiguration

Category	Item	Setting
Device SettingsLogs	Collect Job Logs	Active See Specifying Log Collect Settings.
Device SettingsLogs	Collect Access Logs	Active See Specifying Log Collect Settings.
SecurityUser Lockout Policy	Lockout	Active For details, see User Lockout Function.
SecurityUser Lockout Policy	Number of Attempts before Lockout	5 times or less. For details, see User Lockout Function.
SecurityUser Lockout Policy	Lockout Release Timer	Set to [Active] or [Inactive]. When setting to [Active], set the Lockout release timer to 60 minutes or more. For details, see User Lockout Function.
SecurityUser Lockout Policy	Lock Out User for	When setting "Lockout Release Timer" to [Active], set the Lockout release timer to 60 minutes or more. For details, see User Lockout Function.
NetworkSNMPv3	SNMPv3 Function	Inactive To use SNMPv3 functions, set "SNMPv3 Function" to [Active], and set "Permit SNMPv3 Communication" to [Encryption Only]. Because SNMPv3 enforces authentication for each packet, Login log will be disabled as long as SNMPv3 is active.
SecurityNetwork SecurityIPv4/IPv6	FTP	Inactive Before specifying this setting, set "Network Security Level" to [Level 2] on the control panel.
Security	S/MIME	"Encryption Algorithm": AES-128 bit, AES-256 bit, or 3DES-168 bit You must register the user certificate in order to use S/MIME. The administrator must indicate the strength level that can be specified for the encryption algorithm. For details about specifying an encryption algorithm and registering a user certificate, see Configuring S/MIME.

Device Management

Category	Item	Setting
Address BookDetail InputAdd User/ChangeEmail	User Certificate	You must register the user certificate in order to use S/MIME.