Basic Procedure for Saving Scan Files on a Memory Storage Device
Press [Home] (
) at the bottom of the screen in the center.
Press the [Scanner (Classic)] icon.
Insert an SD card or USB flash memory device into the media slot on the machine's control panel.
For details about inserting an SD card or USB flash memory device into the media slot, see "Inserting/Removing an SD Card", "Inserting/Removing USB Flash Memory Device", For First-time Users.
Make sure that no previous settings remain.
If a previous setting remains, press [Reset].
Place originals.
Press [Store File].
Press [Store to Memory Device].
Press [OK].
If necessary, specify the scan settings according to the original to be scanned.
Example: Scanning the document in color/duplex mode, and saving as a PDF file.
Press [Scan Settings], press [Full Color: Text / Photo] in the [Original Type] tab, and then press [OK].
Press [Original Feed Type], press [2 Sided Original], and then press [OK].
Press [Send File Type / Name], press [PDF], and then press [OK].
For information about other settings, see the each section.
Press [Start].
When scanning batches, place subsequent originals after the scan files have been sent.
When writing is complete, a confirmation message appears.
Press [Exit].
Remove the memory device from the media slot.
Remove the media from the media slot only after data has been written completely. Removing the media while data is being written will result in corrupted data.
The amount of time required to save files to a USB flash memory device or SD card will vary according to the device's specifications.
The documents stored on the memory storage device are not displayed in the list of stored files.
The documents stored on the memory storage device can be printed from the machine's control panel. For details, see "Direct Printing from a Memory Storage Device", Print.
The documents stored on the memory storage device cannot be sent from the machine's control panel.
Depending on the security settings, [Store to Memory Device] may not be displayed. For details, see "Restricting Media Slot Access", Security.
You cannot specify where the data is saved. Files are saved in the root directory of the memory storage device.
If the memory storage device is partitioned, files are saved on the first partition.
You cannot configure file information such as [User Name], [File Name], and [Password].
The amount of free space on the memory device is displayed. Note that if the amount of free space exceeds 10 GB, "9999.99 MB" will be displayed.
To cancel writing, press [Stop]. If files are being written when writing is cancelled, any partially written files are deleted. Only complete files are stored on the memory storage device.