Enabling WSD (Pull Type) Using a Web Browser
To use this machine as a WSD scanner, you must first configure the following settings using a web browser on a client computer: (We use Web Image Monitor installed on this machine.)
Settings to enable WSD (Pull Type)
WSD protocol (default setting: [Active])
To use IPv4, Click [Device Management], click [Configuration], click [IPv4] under [Network], and then enable [WSD (Device)] and [WSD (Scanner)].
To use IPv6, set [WSD (Device)] or [WSD (Scanner)] for IPv4 to inactive (disabled).
In an IPv6 environment, only link local addresses can be used for WSD communication.
[Prohibit WSD Scan Command] (default setting: [Prohibit])
Click [Device Management], click [Configuration], click [Initial Settings] under [Scanner], and then set [Prohibit WSD Scan Command] to [Do not Prohibit].
Use the following procedure to enable both WSD (Pull Type).
Enter "http:// (machine IP address, or host name)/" in the address bar of the client computer's web browser, and then press the [Enter] key.
Click [Login].
Enter login user name and password in the [Login User Name] and [Login Password] boxes respectively, and then click [Login].
Consult your administrator if you require a login user name and password.
On the menu in the left frame, select [Device Management], and then click [Configuration].
Under [Scanner], click [Initial Settings].
Select [WSD] in [Use WSD or DSM].
Set [Prohibit WSD Scan Command] to [Do not Prohibit].
Click [OK].
For details about displaying Web Image Monitor, see "Using a Web Browser", Settings. For details about using Web Image Monitor, see Web Image Monitor Help.