Managing Scan Conditions and Other Settings in the Block Using Distributed Scan Management
Using distributed scan management (DSM) system of Windows Server, you can manage the destination information and scan settings registered under individual users in the block, and use the information when distributing scanned data.
Distributed scan management is supported under Windows Server 2008 R2 or later.
Enable Windows authentication when using this function.
Verifying Users to Operate the Machine (User Authentication)
Specify [DSM] in [Use WSD or DSM] when using this function.
When the security settings on Windows Server is set so that authentication using certificates is required, it is necessary to install the certificate for DSM on the machine. In this case, only the user who has published the certificate can send documents using DSM.
Configure the distributed scan management (DSM) system on Windows Server.
For the procedure to configure DSM, see Windows Server Help.
Login to the machine using Windows authentication.
On the Home screen, press [Scanner (Classic)].
Make sure that no previous settings remain.
If a previous setting remains, press [Reset].
Press [DSM Destination].
Place originals.
If necessary, specify the scan settings according to the original to be scanned.
To change the scan settings, select the [Allow value override at scanner] check box when configuring the device on Windows Server.
Specify the destination.
Press [Start].
Up to 100 destinations can be displayed in [DSM Destination]. If more than 100 scan processes (destinations) are registered to Windows Server, information for the 100 processes that have been registered recently will be displayed in [DSM Destination].
The program function cannot be used with DSM.