Cleaning the Machine
|
Do not use chemicals such as cleaning liquid and organic solvents such as paint thinner and benzene for cleaning. It may seep inside the machine through the gaps or melt the plastic material composing the exterior cover, causing malfunctions to occur.
Your service representative will replace the ozone and dust filters as needed.
Clean the transfer guide board when paper dust causes white spots to appear on parts of the print result.
|
Do not use alcohol or cleaning liquid.
Turn off the power of the machine, and then unplug the power cable from the wall outlet.
Pull the rear cover open lever toward you to open the rear cover.
The transfer guide board is at the location shown in the following illustration.
Wipe the transfer guide board using a cloth that is soaked in water and then thoroughly wrung out. Next, use a dry, clean cloth to remove any moisture.
Do not touch the registration roller.
Close the rear cover.
Plug the power cable into the wall outlet, and then turn on the power of the machine.
Use the cleaning rod provided with the machine for cleaning.
Do not insert the cleaning rod forcefully. Doing so may damage the interior of the machine.
Open the front cover of the machine.
Take out the cleaning rod from the front cover.
While unhooking the claws, pull the handle of the cleaning rod upward.
While keeping the surface with the arrow facing up, insert and then pull out the rod in each of four slots.
Insert the rod carefully until it stops, and then pull it out.
Set the cleaning rod back on the front cover.
While keeping the surface with the arrow facing up, engage the holes on the cleaning rod with the projections on the front cover. Set the cleaning rod so the claws hook firmly.
Close the front cover.