SNMP
Configuration > Network >
SNMP
Use this tab to configure the SNMP settings.
Note
- The administrator can change settings on this page.
Protocol
Make settings for the transport protocol used by SNMP.
IPv4
Specify whether IPv4 is active or inactive.
IPv6
Specify whether IPv6 is active or inactive.
SNMPv1,v2 Setting
The following items are common to SNMPv1 and v2:
SNMPv1,v2 Function
Specify whether to enable or disable SNMPv1 and v2.
SNMPv1 Trap Communication
Specify whether or not to send SNMPv1 trap.
SNMPv2 Trap Communication
Specify whether or not to send SNMPv2 trap.
Community
Community Name
Enter the name of the community to which the network interface board belongs, using up to 15 characters. If the community name is different from that of the hosts, requests from the hosts will not be accepted.
Access Type
In the list, select the access rights to the community.
Not Accessible
No access permitted.
read-only
You can read the information, but not edit it.
read-write
You can read and edit the information.
trap
Notifies the manager with information about errors. Enter the recipient of the error notification in the Manager Address box.
Protocol, Active/Inactive
Make settings for each protocol used by the community.
IPv4
Specify whether IPv4 is active or inactive.
IPv6
Specify whether IPv6 is active or inactive.
Manager Address
Enter the host computer's address according to the protocol in use.
When using IPv4
Enter the host computer's IPv4 address. If you set the access type to "read-only" or "read-write", only requests from hosts with the specified IPv4 address are accepted. Set the address to "0.0.0.0" to have requests accepted from any host. If you set the access type to "trap", enter the IPv4 address of the host to which the information is sent.
When using IPv6
Enter the host computer's IPv6 address. If you set the access type to "read-only" or "read-write", only requests from hosts with the specified IPv6 address are accepted. Set the address to "::" to have requests accepted from any host. If you set the access type to "trap", enter the IPv6 address of the host to which the information is sent.
Extended Security
Select whether to permit SNMPv1/v2 to change access privileges for increased communication security.
Click Execute to set all "read-write" of access type under Community to "read-only".
Buttons
Refresh
Click to update the currently displayed information.
Note
- Before making the settings, click Refresh to obtain the machine's current status.
OK
Click to apply the settings.
Cancel
Click to cancel the settings.