Remote Communication Gate Setup
Device Management > Configuration > @Remote > Remote Communication Gate Setup

The timing of @Remote introduction and the content of its service may vary due to differences between countries, regions, installation environments, and devices used. Ask your sales representative for details.

Note

• Settings on this page can be changed by the following administrator:
  • Machine Administrator

Status

Displays whether the RC Gate is registered.

Request No.

If the status is Not programmed, enter the request number, and then click Confirm to ascertain whether or not the RC Gate can be registered.
If the status is Confirmed, enter the request number, and then click Confirm to register the RC Gate.
If the status is Registered, the request number used to register the RC Gate is displayed.
You can enter up to 31 alphanumeric characters.

RC Gate Location

If you requested the name of the division where the RC Gate is installed, the response is displayed.

Buttons

Refresh

Click to update the currently displayed information.

Note

• Before making the settings, click Refresh to obtain the machine's current status.

Confirm

After entering the request number, click to display the message indicating whether the enquiry was successful.
Click OK on the message page to display the enquiry result.

Program

If the enquiry result page is displayed, click to register the RC Gate.

Back

Click to return to the previous page.