Paper
Device Management > Configuration > Device Settings > Paper

Use this page to configure settings for paper loaded in paper trays, such as size and type, for each paper tray.

Note

Tray Settings

Paper Size

In the Paper Size list, select the size of paper loaded in the input tray.
When Custom Size is selected, also select an appropriate option in the Custom Paper Size box.

Note

Custom Paper Size

Enter the custom paper size when Custom Size is selected.
Enter the length of the paper's short and long edges, in the Horizontal and Vertical boxes respectively, in the units set on the machine (inch or mm).

Note

Paper Type

Select the paper type in the box.

Note

Paper Thickness

Select the paper thickness from the drop down menu.

Note

Apply Auto Paper Select

Select to use the tray when Auto Select is chosen as the paper source.
When On is selected, the tray is automatically selected according to the job settings.
When Off is selected, the tray is not used even if the size and type of paper loaded in the tray matches the job settings. This option can be used to prevent paper loaded in the tray, such as high quality paper and special paper, automatically feeding.

Note

Apply Duplex

Specify whether to use the tray for duplex printing.
Even if On is selected, the tray may not be suitable for duplex printing, depending on the type and thickness of the paper that is loaded in it.

Low Paper Detection

To Top of the Page

Select Threshold for "Almost Out of Paper" Notification

Select a threshold level for the Almost Out of Paper notification on the Status page.

Buttons

To Top of the Page

Refresh

Click to update the currently displayed information.

Note

OK

Click to apply the settings.

Cancel

Click to cancel the settings.

 

To Top of the Page