Auto E-mail Notification
Device Management > Configuration > Device Settings >
Auto E-mail Notification
Use this page to configure settings for e-mail notification of the machine status and error.
Note
- Settings on this page can be changed by the following administrators and users:
- Machine Administrator
- Users logged on
User authentication is enabled on the device and users are permitted to make changes to administrator's setting items.
Notification Message
Enter a comment commonly used for each group where the error notification is sent.
Up to 256 alphanumeric characters can be entered.
You can set this according to your needs, for example, the machine's location, service representative contact information.
Note
- The contents specified in the Notification Message box will be shown as a part of e-mail notification.
Groups to Notify
Group 1 to Group 4
E-mail notification addresses can be grouped as required.
For example, you can organize groups so error notifications are sent to a group where administrators are registered, or low-toner/low-paper messages are sent to a group where general affairs clerks are registered. Up to 3 addresses can be registered in a group.
Click Edit next to the group you want to make changes.
When the Group X page appears, configure the necessary settings.
Select Groups/Items to Notify
Select groups for each notification type, such as machine status and error.
To send an e-mail, select the Notify check box.
To configure detailed notification settings, click Edit.
When the Detailed Settings of Each Item page appears, configure the necessary settings.
Buttons
Refresh
Click to update the currently displayed information.
Note
- Before making the settings, click Refresh to obtain the machine's current status.
OK
Click to apply the settings.
Cancel
Click to cancel the settings.