Use this page to make settings for printing using IPv6.
Note
Select whether IPv6 is active or inactive.
Note
[Ethernet], [Wireless LAN], or [Ethernet + Wireless LAN] appears depending on the interface board installed.
Enter the host name you want to set for the network interface board or wireless LAN interface unit, using up to 63 characters. The default is RNP, followed by the last three bytes of the MAC address of the active interface board. For example, if the MAC address is 00:00:74:62:5C:65, the name is RNP625C65. If you change the name to other than the default, the new name cannot begin with "RNP" or "rnp".
Note
Enter the name of the domain to which the device belongs, using up to 63 alphanumeric characters. Spaces cannot be used.
Displays the link-local address of the network interface board or wireless LAN board.
The link-local address applies only within the local network (local segment) and begins with "fe80::", followed by an identifier generated from the MAC address of the active interface board.
Specify the stateless address of the network interface board or wireless LAN board.
Select whether auto-generation of IPv6 addresses is active or inactive.
Displays auto-generated IPv6 addresses.
In the left box, enter the IPv6 address assigned for the network interface board or wireless LAN board.
In the right box, enter the prefix length of the IPv6 address, using a value between 1 and 128.
The default is 64.
Note
Select whether or not to use DHCPv6-lite to obtain the IPv6 address from the DNS server.
Select whether DDNS (Dynamic DNS) name resolution for the network interface board or wireless LAN board is active or inactive.
When active, the DNS database is immediately updated.
Enter the default gateway address.
The default gateway address is the IPv6 address of the host or router used as the gateway when communicating (printing or exchanging information) with a computer on another network.
If [Stateless Address Autoconfiguration] is set to [Active], the link-local address of the router is set as the default gateway address.
If you specify a default gateway address here, that address is used.
The value currently in use appears in parentheses.
Note
Select whether to use the DNS server obtained from the DHCP server, or the DNS server set for the device.
[DNS Server1(DHCP)], [DNS Server2(DHCP)], and [DNS Server3](Auto-Obtain(DHCP)) are accessed in this order, and the DNS server that responds first is used.
[DNS Server1], [DNS Server2], and [DNS Server3](Specify) are not used.
Even if "Auto-Obtain (DHCP)" is selected when DHCP is not used, the operation is the same as when "Specify" is selected.
[DNS Server1], [DNS Server2], and [DNS Server3] are accessed in this order, and the DNS server that responds first is used.
The primary DNS server IPv6 address obtained from the DHCP server appears.
The secondary DNS server IPv6 address obtained from the DHCP server appears.
Enter the DNS server IPv6 address you want to set for the machine.
Note
Enter the DNS server IPv6 address you want to set for the machine.
Note
Select whether each protocol is active or inactive.
When printing using WSD (Web Services on Devices) or IPP, specify the time the machine waits for job data before canceling the job.
You can specify a timeout period of 30 to 65535 seconds.
The default timeout period is 900 seconds.
Select whether or not to enable printing using RHPP (Ricoh Host Print Protocol).
Click to update the currently displayed information.
Note
Click to apply the settings.
Click to cancel the settings.