Access Control
Configuration > Security > Access Control

Specify the computers to be allowed access (print request, page displaying etc.) to the machine.

Note

• Settings made here relate to the following interfaces:
  Ethernet and wireless LAN.
• Access using the TCP/IP protocol is restricted.
  Restricted IP address computers cannot access Web Image Monitor. However, Remote Maintenance operations (mshell) are not restricted.
• Settings on this page can be made only when you are logged on as Administrator.

IPv4

To use IPv4, make the following settings:

Access Control Range 1 to Access Control Range 5

Enter the IPv4 address range of the computers to be allowed access to the machine.
Up to five sets of ranges can be entered. Access from addresses not included in these ranges is prohibited.
If specifying less than five sets, set the unspecified ranges to [0.0.0.0]- [0.0.0.0].
To allow access from all computers, set all ranges to [0.0.0.0]- [0.0.0.0].

IPv6

To use IPv6, make these settings.

Access Control Range 1 to Access Control Range 5

Enter the IPv6 address range of the computers to be allowed access to the machine, using the IP address range or a combination of base address and mask.
Up to five sets of ranges or prefixes can be entered. Access from addresses not included in these ranges or prefixes is prohibited.
To specify a range, select [Mask], enter the base address, and then enter the mask range in the [Mask Length] box using a value between 1 and 128.
If specifying less than five sets, set the unspecified ranges to [::]- [::].
To allow access from all computers, set all ranges to [::]- [::].

Note

• A multicast address cannot be defined as a base address.
• The default is 128 for [Mask Length].

Buttons

[Refresh]

Click to update the currently displayed information.

Note

• Before making the settings, click [Refresh] to obtain the machine's current status.

[OK]

Click to apply the settings.

[Cancel]

Click to cancel the settings.