Interface Settings
Configuration > Interface >
Interface Settings
Use this page to enter administrative information related to the machine's interfaces.
Some items are for reference only and cannot be changed.
To make settings for the wireless LAN board, use the [Wireless LAN Settings] page.
Note
- These settings can be made only when you are logged on as Administrator; otherwise, the machine's current settings for each item are displayed.
Ethernet
Network
Switch the interface between Ethernet and wireless LAN. This is available only if the device supports both interfaces.
Note
- When "Ethernet" is in use, the switching option is not available.
Ethernet
Displays network interface board information. This information appears when a network interface board is installed.
Network
Displays Ethernet operation status.
MAC Address
Displays the MAC address (Media Access Control Address) of the network interface board.
Ethernet Security
Select whether or not to use IEEE 802.1X as an authentication method to protect data communication.
To make detailed settings, use the [IEEE 802.1X (WPA/WPA2)] page.
Ethernet Speed
Ethernet communication speed. For normal use, select "Auto Select". This allows the device to select the optimum speed.
If communication with the device fails, select "10Mbps Full Duplex", "10Mbps Half Duplex", "100Mbps Full Duplex", or "100Mbps Half Duplex".
USB
Configure USB settings.
USB
Select whether data transfer via USB is active or inactive.
USB Host
This appears when data transfer via USB is active and the device supports USB Host.
USB Host
Select whether USB Host function is active or inactive.
Buttons
[Refresh]
Click to update the currently displayed information.
Note
- Before making the settings, click [Refresh] to obtain the machine's current status.
[OK]
Click to apply the settings.
[Cancel]
Click to cancel the settings.