SMB
Configuration > Network >
SMB
Make settings related to SMB.
Note
- Settings made here relate to the following interfaces:
Ethernet and wireless LAN. - Settings on this page can be changed by the following Administrators and Users:
- Network Administrator
- Logged-on Users
User authentication is enabled on the device and Users are permitted to make changes to Administrator's setting items.
SMB
Select whether SMB is active or inactive for the interface board.
Protocol
Displays [IPv4] as the transport protocol used by SMB.
Note
- IPv6 is not supported.
Workgroup Name
Enter the name of the workgroup the interface board belongs to.
The default is WORKGROUP.
Up to 15 characters (excluding " * + , / : ; < = > ? [ \ ] | . and spaces) can be entered.
Computer Name
Enter the name for identifying the device when using SMB.
The default is RNP, followed by the last three bytes of the MAC address of the network interface board or 802.11b interface unit.
For example, if the MAC address is 00:00:74:62:5C:65, the name is RNP625C65.
Up to 15 characters (excluding " * + , / : ; < = % > ? [ \ ] | . and spaces) can be entered.
If you change the name other than the default, you cannot begin the new name with "RNP".
Assign a name that does not belong to other devices in the network.
Comment
Enter the comment set for the interface board. Up to 31 characters can be entered. This is the same item as the [Comment] box on the [Configuration] - [Device Settings] - [System] page.
Share Name
Displays the model name of the printer to which the interface board is installed.
Notify Print Completion
Select [Active] to receive notification of print completion. For Windows 95/98/Me, to receive completion notification, execute WINPOPUP.EXE in the [Windows] folder to start the Popup Service.
Buttons
[Refresh]
Click to update the currently displayed information.
Note
- Before making the settings, click [Refresh] to obtain the machine's current status.
[OK]
Click to apply the settings.
[Cancel]
Click to cancel the settings.